Skip to main content
Home » Jeep Hitches & Racks » Towing Accessories » Towing Wiring Harnesses » Mopar RV Towing Harness
« Back to product
Can this harness be used with a 2024 Wrangler 392?
It is applicable for 2024 models as well. Thanks for your inquiry.
Is it possible to order just cable A and connector E. Having problem with just right turn indicator and narrowed down to this connector/cable. Also, is it possible to disassemble connector E?
Unfortunately the only component that is available separately is the jumper wire to connect vehicles
is this harness supposed to keep the jeep battery charged? I have this installed in a 2018 Moab and works great except we ran the RV for 2 days straight without ever disconnecting or starting the jeep. When we got home the jeep was dead and had to be jumped. If this is right, can I add a charge wire from the RV 7 way to the jeep battery without interfering with this harness?
No, this is not designed to charge the battery.
Can I buy just the plug from motorhome to front bumper plug? Mine either was stolen or came off on one end while traveling and lost.
Yes, Mopar sells the front jumper as 68452777AA . That has been added to the Our Experts Recommend area
RE: Jeep Wrangler Sport S 2 DR Hello, With this part also work in the above noted 2021 model? Thx, Erik
Yes this will work on the new 2021 models as well.
Steps 68 and 69 show a harness labeled “C”. Is this the same harness that is labeled “A” in the graphic in step 11?
Yes in this case what is labeled as "C" is still "A" from above. They are circling around at the end to finish exterior connections.
The title on Step 42 of the instructions says “ROUTE HARNESS (B) UP TOWARD PASSENGER SIDE TAIL LAMP”. However the graphic in step 42 shows the harness is labeled “C”. Please clarify if the graphic labeled C is incorrect and should be labeled “B” or if the title in the instructions that says harness “B” is incorrect and should say harness “C”i
In this section #42 looks to be mislabeled. This should read "Route Harness C" as you are working with the wiring that is preterminated to connect with the tail lights and license plate lamp.
Harness “C” is shown in step 14 of the instructions. However step 11 in the instructions shows what appears to be the same harness as “A”. Please clarify if the harness shown in step 14 is harness “C” or harness “A”
Step 14 is illustrating the connection with wiring section "A". Once this is run from the battery and the terminals are set in the connectors E and F this will connect to G (trailer connector wiring). This looks to be mislabeled on the instructions
I have fitted the Riv harness to my JLU in conjunction with the 7 pin Mopar tow harnes and the rear indicators will not work, disconnect the rear rev harness and the indicators function perfectly Any ideas what I’ve done incorrectly
Did you have the dealership flash the system after installation?
will this work with the JT? Is the harness long enough?
This will not work on the Gladiator JT for other reasons as well as the length. We hope to see an RV harness for the JT soon.