« Back to product
Ricky Q.
can you clear engine codes with this unit
This will read & clear diagnostic trouble codes. Thank you for the question.
Alan S.
I have a 2014 Rubicon and replaced the auto disconnect anti-sway bar with an anti-rock. Will this remove the sway bar alarm on the dash? Thanks.
No, it will not. Thanks for your inquiry.
Peter K.
Will this allow engaging lockers in 2wd and 4 hi?
Locking axle options with transfer case in 4-Hi & 4-Low (Rubicon only). There is no selection in 2wd. Thanks for your inquiry.
Jed P.
Will this programmer allow you to change shift points?
Through tire calibration automatic shift points will be improved but you cannot set custom shift points with the programmer. Thanks for your inquiry.
Dirk H.
Hello,will the Flashcal work on the 2.8crd?
No these are for the gasoline motors only.
Grant Y.
Does this have to stay plugged in to work or can you program and then unplug ?
No, you unplug the programmer after use.
Stefan S.
I have to leave it plugged in all the Time?
No, you unplug the programmer after use.
Louis G.
Can the reprogrammed be used on multiple jeeps? If I reprogram my jeep, can I lend the device to my buddy so he can reprogram his jeep? Thanks
Unfortunately not, they would be programmed to your specific VIN once plugged in. There is not way to run them for multiple Jeeps at this time.