Reviews for Auto Meter A Pillar Dual Gauge Pod for 07-18 Jeep Wrangler JK

Ok I installed the a pillar this morning.. it fit perfectly.. do not get discouraged when installing.. u have to remove the plastic plug holding the wire harness.. and I actually opened the hole just a bit ..I didn't want to damage the pillar.. but after everything is reinstalled the pillar fit tightly and gauges look awesome..

Easy install and looks oem Just what I wanted.

Ran Transmission temp gauge as well as water pressure. Easy install just wish the gauges themselves came with the 18 gauge wire required for installation.

Nice gauge pod. I installed Transmission Temp and Oil Pressure gauges. The pod was perfect for my usage

This came out nice after I finally got the volt gauge wired in and Oil line ran. The one thing I suggest to installing this is take the time to find a Course Bolt, about 3/8, with a wide shoulder on it, and replace the upper snap plastic piece, that goes into the hole above the gauges on the right side, Tightens up everything nice & clean, It was an afternoon Project

Fits good and works as advertised. Great for my oil pressure and voltmeter gauges.

Easiest pillar pod I've ever installed. No drilling required. Mounts in OEM holes already located on the a-pillar. You do have to move an existing wiring harness. Guages sit in the pod very nicely and are viewable.

I had the single gauge pod before and it worked great. With this one however, the gauges do not seat flush. I am using auto meter brand gauges. I had to do some trimming here and there to get them close enough to not look bad. So it works, but could be better.

Had to sand out the gauge openings to get the gauges to fit. The gauge mounting clamps would not fit due to insufficient clearance on the back side. Drill template not included so I had to mark it myself which fortunately worked well. I would not purchase this again.