Reviews for Quadratec 12 Volt Power Adapter for 99-18 Jeep Wrangler TJ, JK, TJ Unlimited & Wrangler Unlimited JK
Quick way to add a power source without the hassle of splicing plumbing wires.
Directions were easy to follow and easy to install. Exactly as pictured, and did what I wanted. Have a switch pod controlling lights etc, now wired so when the ignition is off, all accessories are off. Needed so somebody can't flip them on when the top is down, and drain the battery.
Just what I needed. I wanted to wire up a dash cam and put a charging cable for my phone in the dash. To do this I used this cable, hooked it up to a couple of terminal blocks, and connected up a couple cigarette ports to plug in the cables. It all fits very nice in the space under the glove box.
I probably could have wired something like this up myself, but to have it pre-made helps to keep my mind at ease.
I was at fist confused why the instructions skip the pre-2011 JK. However, it turns out once you get the center bezel disassembled it's pretty clear how to connect it and the connectors all work on my '07. Wondering why, on a 2007, you couldn't just hook one of these into both the right and left outlet and have two.
used to power back up camera
Perfect fit. Easy installation. Just a bit expensive for what it is.
The only downside is how expensive it is for something so simple; you could make it yourself for a fraction of the price.
But if you are lazy like me, this item is prefect! It works straight out the box! The installation is quite easy too. I was scared about ripping the whole dash apart but it turned out to be surprisingly easy. The only tip I can give you is when removing or installing the the big top piece of the dash, lower the steering to the minimum adjustment, it will give more clearance for the plastic piece to go on and off.
Good instructions. One note is when removing the vents, it states to insert screwdriver at the 1:00 position. When you do, look for a hole to insert the screwdriver. That will unlock the vent to move to 11:00 and ultimately remove it. Everything else was easy!
Connected right up to my TJ factory harness to power my CB radio. Would have given five stars but included instructions were only written for JK’s.
Expensive but does exactly what it’s supposed to do. Installed on a 04 TJ which has no additional power accessory sources behind the glove box as earlier models have. An easy installation but tight fitting it all in behind. Re-routed the tap lead up behind the heater/air switches and then down to the driver’s area. Works perfectly!