Skip to main content
Home » Jeep Lighting, Lenses, Bulbs » Lenses, Housings & Parking Lamps » Parking Lamps » Crown Automotive Parking Lamp and Turn Signal Kit

Reviews for Crown Automotive J0989852 Parking Lamp and Turn Signal Kit for 69-75 Jeep CJ

< Back to the product
JESSE E.
4/19/2024
5

Perfect fit
1974 JEEP CJ5 V8 5.0 304 c.i
Made my own wiring harness
Guest
1/8/2022
5

Price and availability
Jerry V.
9/18/2019
4

Great replacement. It would be nice if it included the brass nuts.
Paul I.
7/7/2022
3

Bought 2 of these for a 1974 CJ-5 the old ones worked but were rusty crusty. Replaced both and front side marker lights were not working? Had to cut and splice the side marker light jumper wire (blue) to the parking light wire (red) to get them to work P.I.A. One connector came off in my hand, but they do come with bulbs. So check B4 you button up everything.
Grant R.
5/4/2022
1

Same here, not clocked in any position and no spring to make contact with bulb.
Dale P.
5/9/2021
1

Absolute garbage.pins at base collapse into rubber rendering contact to bulb impossible. Light socket is not clocked correct with pins to allow constant contact to bulb. I ended up cutting off wire, removed rubber and pins and installed a new pigtail in base with a spring. These should be yanked from the shelf and not sold.
David S.
5/22/2020
1

I have done over a dozen Jeep restorations and purchased from quadratec for over 15 years and will continue to purchase from quadratec but these turn signal lenses are absolutely garbage. First off one of the threaded studs does not line up in the grill so you will have to drill one hole for each turn signal. Second after installation went to plug into my stock wiring and one of the wires just pulled right out of the housing. I had to cut the plug off my old turn signals and splice it into the new turn signal. Then went to install the second turn signal plugged it in turn on my lights and 1 bulb was brighter than the other and would not work with my headlights on. I thought it was a grounding issue but it turns out the wiring was wired backwards on that turn signal again at to cut the wires and splice it correctly. If you can just purchase the lenses and use those with your old turn signal housings. Do not recommend these at all. Again I do not hold this against quadratec and usually have good luck with crown but these should not even be sold.