Reviews for Crown Automotive Shift Knob for 80-86 Dana 300 Transfer Case

exactly what was shown

Just as described.

Not much to say other than this replaced my worn out cracked knob looks nice especially when you are doing a restore like I am.

The shift pattern insert that came with the knob had a raised burr all around the edge of the insert making it impossible to insert even when I heated up the knob with a hair dryer.

Trimming off the burr with a pocket knife and then inserting it into the knob was a lot easier especially after heating the knob with the hair dryer.

The finished product looks great.

Insert is difficult to glue on knob, isn't same width as cutout, not big enough