« Back to product
Jason G.
Is there a way to order just the mounting hardware, I'm transferring them from one jeep to another, and lost the hardware. Thanks
We do not carry hardware packs to fishbone offroad or other vendor products. Reaching out to the vendor and a Jeep specialist and it might be possible to arrange a special order. Thanks for your inquiry.
Alexis H.
These don't look like they accommodate the side marker lights on stock JK fenders. What do you do for the light? Just unplug and tuck the wires?
Most people cut a 3/4" hole in the fender, either upfront facing forward or on the underside facing sideways, and install a 3/4" LED. Part # 12160.3900 for example. It says for TJ, but will work for any 3/4" round installation. Cutting & splicing or using a t-tap(s) is required.
Glorimar M.
How wide are the front fenders?
They are approximately 8" wide at their widest point above the tire.
DAVID E.
Since these fenders fit factory holes, why do we need to remove the factory wheel well covers? Couldn't they stay on to protect the wheel well and engine compartment from mud, etc.?
The factory inner fenders use the outer fenders for some of the mounting support holes. The OE outer fenders have plastic clips on them that support the plastic inner fenders. You can keep your plastic inner fenders if you trim them back to prevent them from flapping in the wind.
Paul U.
Are there side marker brackets and or a side marker light kit than works with these fenders?
For these fenders you would have to drill in order to install side markers such as 12252.3900
Zackary F.
Can you paint these fenders?
You would need to have the powder coating stripped off prior to priming and painting.
Douglas R.
Are these fender flares any wider than stock?
Hello, these flares are not as wide as stock flares. If you measure from under the hood latch, the flares are 8”. Then at the bend location they are 7-1/2” wide. Rear flares are 5-3/8” wide. Thank you for your question.